Features: Aluminum construction, Fully assembled, ready for use.

The Cayuga 2-boat rack is the first in the new Finger Lakes series from Talic. Itš „ ´s a freestanding system capable of holding two kayaks. The brackets are designed to gently cradle your boats on their sides, resting them on soft webbing and protecting them from scratches and dents. Sit-on-tops, recreational, touring, and even whitewater kayaks fit comfortably on these racks. The Cayuga comes partially assembled, making it easy to finish up at home. Just four bolts and it's done, yet it has the strength to stand firm.Please note: Not recommended for outdoor use.

The Rhino Rack Side Boat Loader is a revolutionary product designed to take the hard back breaking work out of lifting your small boat on and off your vehicle's roof. With simple one man operation, you can easily winch your aluminum boat up & down from your vehicle with a battery powered cordless drill (Rhino recommends 18 volt drill). The side boat loader can be used on a range of vehicles including 4WD's, low roof camper vans and station wagons. The basic principle is in dragging the boat up two ramps set at approx a 50 degree angle to the ground and over the top of the vehicle by means of a 40/1 worm drive gear which turns the winding roller. Ropes are attached to the far side of the boat and also 2 shorter gunnel ropes are attached to the near side. When lifting commences, the boat is “flipped” over and then slides up in the inverted position. The key requirement in loading and unloading is that the vehicle must be on level ground as the ramp structure and main support cross bars are extremely slippery. A second person can always be used in adverse conditions to stabilise and stop any forward or rear excessive slippage.

Malone foam block car top canoe carrier kits & blocks offer an affordable transport system for your canoe. We use high quality EVA closed cell foam. All of our blocks are produced with state of the art computer fabrication to insure total quality. The Standard Canoe Kit includes everything you will need to safely transport one canoe. We included two polypropylene over-hull straps and bow and tern lines to insure a safe transport for your boat and fellow drivers on the road.

SHELFMOUNTED MEAT BOAT RACKMOUNTING:Shelf MountDIMENSIONS: 12"W x 48"L x 25"HMATERIAL: Stainless SteelFREIGHT CLASS: 55PACKAGE SIZE: 1 per case meat|mounted|rack|boat|kithenware|food|beef|poultry|holder|stainless steel Furniture

The little brother to the hullraiser aero saves you some dough, mounts to either round or square bars, and proves that boat security and ease of loading run in the hullraiser family.

Pot Rack ceiling mount boat-shaped 48"L 3/16" x 2" stainless steel flat bar includes (12) stainless steel double hooksFEATURES: PRB05 120" 30* Pot Racks are fabricated from 2"x3/16" Stainless Steel flat bar16 gauge type 300 stainless steel with # 3 polish, satin finish* Uprights are 1 5/8" O.D. Round 16 gauge tubing, type 300 stainless steel with # 3 polish, satin finish* Table or Ceiling Mount (Please Specify)* All Pot Racks feature Welded-Set-Up* Pot Hooks are Removable and Stainless Steel* Table mount Pot Racks are 48" total height above work surface* All models are approved by the National Sanitation FoundationCONSTRUCTION:* Stainless Steel Pot Racks are TIG welded Exposed welds are polished to match adjacent surfaces MATERIAL: Frame: 2" x 3/16" Flat Bar, 16 gauge type 300 stainless steel # 3 polish, satin finish Uprights: 1 5/8" Round O.D., 16 gauge type 300 tubular stainless steel # 3 polish, satin finish Hooks: Stainless Steel boat shaped pot rack|ceiling mount pot rack|pot rack|stainless steel Home

The Lash Lock rack guard gives you piece of mind when you leave your surf board, kayak or bike unsupervised on the car rack. Just loop the cable over the boat and under the crossbars. The end of the cable snaps into the lock, which then swings closed, tightening the cable securely around your boat. Unlocks with a three-digit combination that you choose. Includes lock, 13' cable, and instructions.Lash Lock Specs: * Material: Super flexible plastic coated aircraft cable * Length: 13' Cable * Three digit combination

The Malone SeaWing universal car rack kayak carrier includes everything you need to carry one kayak bottom down on your roof top or trailer. The unique mid-mount design saves space and allows you to fit two kayaks bottom down on factory or after market cross rails. (with a second set of SeaWing carriers) The universal JAWZ™ mounting hardware fits round, square and factory oval cross rails.